Thread: $4 sissy bar
View Single Post
Old 07-26-2015, 09:48 PM
MotoMagz's Avatar
MotoMagz MotoMagz is offline
Motorized Bicycle Elite Member
Join Date: Aug 2010
Location: Michigan
Posts: 1,197
Default Re: $4 sissy bar

Could you weld a base out of some small angle iron? Then weld a couple pieces of flat bar across for a base. Then go to a place that sells foam. We hBe the Foam Factory here in Mi. They have all types that can be good with a electric fillet knife,files and sand paper. Then you can cover it with material of your choice. I'm thinking the base would be much smaller than the foam top..kinda
like a muffin top. So you would be carving bottom of seat (foam) to fit into the base/angle iron...then I got to much sun do ya get what I'm thinking?? Just a idea!.
Reply With Quote