Thread: Frame question
View Single Post
Old 07-09-2015, 03:43 AM
dtv5403 dtv5403 is offline
Motorized Bicycle Elite Member
Join Date: May 2015
Location: USA
Posts: 324
Default Re: Frame question

So here's what I did. I finally found some string I had laying in a box. My frame has holes in the rear dropouts, they aren't for fenders but they're there so whatever lol. My frame is also a double top bar frame, the kind you could mount a tank between the bars. So I ran the string through the hole in one dropout, between the double top bars and through the hole in the other dropout. I then took my tape measure and ran it from where the seat tube meets the bottom bracket to where the string came out of each hole. On both sides I got exactly 18.5". I suppose I could have measured without the string, but I think the string gave me an easier point to measure to. Anyway, I'm assuming since the distance was the same, the dropouts are spread evenly apart?
Reply With Quote