View Single Post
Old 02-14-2009, 07:25 PM
Roadkill's Avatar
Roadkill Roadkill is offline
Motorized Bicycle Elite Member
Join Date: Feb 2009
Location: Roadkill, USA
Posts: 242
Default Re: Bike Stand For Motorized Bikes With Suspension Forks

OK I do not have pictures of this but I welded to my rear rack a 1 1/2" pipe section a foot long and drilled holes through the pipe 1" that went through it on which I mounted an American flag while riding. A bolt or pin will hold the pole in up (flag) or down (stand) position. I only did this for an oversized weight kickstand on the riding position left side. I image now that I could have used two and had a rear wheel stand using just pipes and drill bits and my trusty 80 dollar wire feed.

Hope that helps someone.
Reply With Quote