Thread: Finally! Hello
View Single Post
Old 05-05-2015, 07:46 PM
2door's Avatar
2door 2door is offline
Super Moderator
Join Date: Sep 2008
Location: Littleton, Colorado
Posts: 16,224
Default Re: Finally! Hello

No need for heat bending EMT conduit. It bends cold just fine.

Unless you cheat and do what we call, 'bump bending' you're restricted to the radius of a conduit bender. If you cheat, or bump bend, you can get a little tighter bend radius without kinking the pipe. Doing this you need to take your time and bend just a little slowly. Typically though, the radius you'll get from a standard conduit bender will suffice for most bends required to build an exhaust.

Age and Treachery Will Always Triumph
Over Youth and Skill & "Charlie Don't Ride"
Reply With Quote