View Single Post
Old 04-18-2015, 09:27 PM
DRBS's Avatar
DRBS DRBS is offline
Motorized Bicycle Elite Member
Join Date: Jun 2014
Location: Westland MI U.S.A
Posts: 265
Default Re: what did you do to your motorized bicycle today?

I found some on e-bay its 1.25 id and1.50 od I figure that cutting it into two pieces will leave enough so that there is room for forming it around the hub I'm also going to use a chisel to add a few gouges in the inside and out side to keep it from spinning on the hub also do the same to the inside of the hub adapter better safe than sorry but ill try it slowly to make sure it doesn't slip ill mark the hub and the adapter to check that it isn't moving if it does then back to the drawing boards I just might use a 1" one and use a hole saw and re cut the hole 1.25 well actually 1.20
hang on a second I think ill use my nox now
Reply With Quote