View Single Post
Old 03-20-2015, 06:00 PM
curtisfox curtisfox is offline
Motorized Bicycle Elite Member
Join Date: Dec 2008
Location: minesota
Posts: 3,523
Default Re: what did you do to your motorized bicycle today?

Originally Posted by Blakenstein View Post
ya, its a little trick I learned in high school small motors. ( 4 stroke lawn mower ) , but the gap then was much smaller like two peices of writting papper.
On my 48cc Bridgestone the factory gap is 3 fag pak cardboards.
My clutch pads are worn out bad so im gonna get new one from dealears, they sell same motors as boat trolling motors now, but clutches are the same.
Anyway, i find my clutch on websites for $13.oo however, the Bridgestone factory clutch is $ 70.oo . I'll get the Bridgestone clutch and then get HP springs fron other websites.
Yep for Briggs use a recipe card bring the coil down to the magnets with it in tighten it up and work the card out good to go........Curt
Reply With Quote