View Single Post
Old 02-20-2015, 08:57 PM
Earbiter Earbiter is offline
Motorized Bicycle Member
Join Date: Oct 2013
Location: Denver, Colorado
Posts: 38
Default bending aluminum frames

My mountain bike has a strange design for the seat stays and I am trying to put a larger sprocket on it but the chain is rubbing. So I was wondering if anyone has had success bending an aluminum frame, or are there any other methods out there? I think I may need to use a shim or two as well to move the sprocket towards the center of the wheel, but that only goes so far. I'm talking about 1/4 of an inch total that the chain needs to move.
Reply With Quote