View Single Post
Old 01-28-2015, 11:23 PM
Davezilla's Avatar
Davezilla Davezilla is offline
Motorized Bicycle Elite Member
Join Date: Mar 2014
Location: San Antonio Texas
Posts: 2,710
Default Re: Curious about the engine, :question:

I'll do a few more checks when I get back to the shop tomorrow if things are slow enough in the morning... I just got the jug off and the bottom end temporarily put together, and got a piece of aluminum bar stock with an old roller bearing for doing my mock ups with the wrist pin and piston... I also got that titanium wrist pin and bronze bushing I can use for a more accurate mock up install... I don't trust to run it with that pin in there anyway, and the pin and bushing do come out a tad heavier than my steel pin and needle roller bearing. Once I take the rest of the measurements I'm going to pull out the crank and work on cutting a hole in the case for a case inducted reed setup.
Reply With Quote