View Single Post
Old 01-26-2015, 06:50 PM
HDCowboy's Avatar
HDCowboy HDCowboy is offline
Motorized Bicycle Member
Join Date: Jan 2015
Location: Texas Gulf Coast
Posts: 44
Default Another new guy and 1st build on GT2 frame

Well it all started when I seen a few pics of that new Felt Deep Six bicycle on the net and while searching for more info on it I ran into BikNuts Youtube video he did of a motorized engine build he did on one and it got my created mind flowing.......

I was even fixing to order one from the local bike shop when I discovered this board and realized you had to strip it all the way down to the frame just to seal the tank. After reading about tht GT2 frame I figured if I was gonna start a frame up build why not start with a new frame to begin with and I might even save a few bucks. I think I was a little bit wrong on that point there though after realizing a majority of the parts of my old Cannondale I had out sitting out in the barn I planned to use as a parts bike wasn't going to work to well on the GT2 frame.

Regardless I found me a Skyhawk GT2-A frame and and a set of Monark springer forks on Ebay, ordered them along with a couple cheap 2 stroke kits I found online and started my build.......
Attached Images
File Type: jpg IMAG0187.jpg (215.8 KB, 84 views)
File Type: jpg IMAG0188.jpg (99.5 KB, 85 views)
File Type: jpg IMAG0189.jpg (105.0 KB, 81 views)
File Type: jpg IMAG0190.jpg (216.0 KB, 71 views)
File Type: jpg IMAG0192.jpg (139.8 KB, 102 views)
Reply With Quote