Thread: Mill/Lathe
View Single Post
Old 12-23-2014, 07:58 PM
Greg58's Avatar
Greg58 Greg58 is offline
Motorized Bicycle Elite Member
Join Date: May 2011
Location: Newnan,Georgia U.S.A.
Posts: 2,620
Default Re: Mill/Lathe

Dan That's the same way you install a flywheel ring gear, I was amazed the first time I changed one. I knocked the old one off and just heated the new gear with a aceteline torch, it dropped right on, then I tapped it down flush and let it cool.
Your results may not be the same,Greg
Reply With Quote