Thread: Mill/Lathe
View Single Post
Old 12-23-2014, 07:36 PM
Dan's Avatar
Dan Dan is offline
Join Date: May 2008
Location: Moosylvania
Posts: 11,850
Default Re: Mill/Lathe

LOL w/ ya both. Ayup an' for sure.

Actually kinda proud of finally getting that right. Needed 2 holes 1.5 inches apart. Dang dial is in mm's. @ 0.06! Took an hr but figured it out, eventually.


Keep forgetting this. The "thumb press", bearing fitting works great! Chill the bearing and heat the housing and it pops right in. So far, so good.

The shop is 30 to 40F most days, so chilling was not hard.
worst apocalypse ever
Reply With Quote