View Single Post
Old 12-22-2014, 11:29 AM
crassius crassius is offline
Motorized Bicycle Elite Member
Join Date: Sep 2012
Location: USA
Posts: 2,784
Default Re: Today I made the first test run

if both the usual adjusters are all the way out, one can get a bit more by turning the elbow fitting on the throttle grip body out a bit, but be careful as that is only mounted into plastic and can crack easily

one can also get a tiny lock washer, open it a bit to fit over inner at the top of the carb, then squeeze it closed again to hold the cable outer a bit off the carb top rather that seated down in the socket there

be sure the plastic stop inside the throttle grip is still there, as sometimes this gets bad and a small piece of metal needs to be added inside to make a new stop
Sometimes I sets and thinks, sometimes I jes sets.
Reply With Quote