View Single Post
Old 12-21-2014, 07:14 PM
Greg58's Avatar
Greg58 Greg58 is offline
Motorized Bicycle Elite Member
Join Date: May 2011
Location: Newnan,Georgia U.S.A.
Posts: 2,620
Default Re: Today I made the first test run

Flyman I had one cable that was too long for the cns2 carb when it first came out, I found a bicycle cable kit at Walmart that had a split adapter that I put at the grip end and it worked perfect. I ran that set up for about three years. Out of the six kits I've built one nt carb wouldn't idle with the needle in the leanest position, I move the clip down one notch and it idled like it should, it seemed that the needle was a bit long from the factory.
Your results may not be the same,Greg

Last edited by Greg58; 12-21-2014 at 07:17 PM.
Reply With Quote