Thread: Mill/Lathe
View Single Post
Old 12-19-2014, 05:04 PM
Dan's Avatar
Dan Dan is offline
Join Date: May 2008
Location: Moosylvania
Posts: 11,850
Default Re: Mill/Lathe

Any pictures, Chain. Still sounds cool.

got me thinking a shaft driven by a shaft. The former sliding inside the pulley.........

================================================== ====

Oh No, Dave. I did not mean to say that using a drill press as a mill (laterally) is at all a good idea!

If the bearings hold, the chuck will fly off. As you said

But properly supported and a proper receiver, it would house and work well.
worst apocalypse ever

Last edited by Dan; 12-19-2014 at 05:06 PM.
Reply With Quote