Thread: Mill/Lathe
View Single Post
Old 12-19-2014, 04:51 PM
DaveC's Avatar
DaveC DaveC is offline
Motorized Bicycle Elite Member
Join Date: Jul 2010
Location: Boise, ID
Posts: 967
Default Re: Mill/Lathe

Originally Posted by Dan View Post
Have you considered making one, IWW? Hmmm, bet a drill press could be shored up and then just need a cross slide vice....

Not the kits though. Most have plastic gears. That I have seen.
Drill press will work until the first time you get chatter. Then it will spit the chuck right off the taper.
Reply With Quote