Thread: Mill/Lathe
View Single Post
Old 12-14-2014, 03:11 PM
Dan's Avatar
Dan Dan is offline
Join Date: May 2008
Location: Moosylvania
Posts: 11,850
Default Re: Mill/Lathe

been pulling my hair out trying to figure out how to remove 1/32 off an intrinsic key (keyway, key) inside a 3/4 sheave. That's .0135 of an inch.

Wanted to broach it but would have to have a bushing made made. Couldn't find one at least.

Then it dawned on me while talking to Greg on the phone and led me to this thought. I got a mill/lathe, LOL! So just made one.

I gotta make another but this will work. I hope.

This is "Stubby the wonder bushing"
Attached Images
File Type: jpg larry stubby the bushing.jpg (561.2 KB, 32 views)
worst apocalypse ever
Reply With Quote