View Single Post
Old 11-28-2014, 06:44 PM
Msiert's Avatar
Msiert Msiert is offline
Motorized Bicycle Senior Member
Join Date: Sep 2014
Location: Omaha NE.
Posts: 54
Default Re: what did you do to your motorized bicycle today?

Last night I had everything put back together after installing a new 48 tooth drive sprocket and noticed the rear wheel had a pretty decent amount of side to side movement that it didn't have before.

Found out by reading this forum last night that by my moving my coaster brake arm when the axle nut was snug down on the peddle sprocket side that I messed up the hub bearing adjustment. Errr...

So today rear wheel came off to adjust the hub's bearings and then I put it all back together and adjusted the chain tensions...again. Tomorrow suppose to be in the low 50's F a great day for a ride.

It will be the first time out since adjusting my valve lash to .004 intake and .005 exhaust. It was .005 intake and .008 and ran fine, kinda wondered if I needed to do it? Tomorrow will tell.
Attached Images
File Type: jpg image.jpg (405.9 KB, 39 views)

Last edited by Msiert; 11-28-2014 at 06:54 PM.
Reply With Quote