Thread: Mill/Lathe
View Single Post
Old 11-23-2014, 12:20 PM
Greg58's Avatar
Greg58 Greg58 is offline
Motorized Bicycle Elite Member
Join Date: May 2011
Location: Newnan,Georgia U.S.A.
Posts: 2,621
Default Re: Mill/Lathe

Dan if you're ending up with a rough surface either your feed rate is too fast or the bit angle is wrong. On our lathe a little adjustment does a lot. You want the very tip to touch and slightly below center of the shaft you are turning.
Your results may not be the same,Greg
Reply With Quote