Thread: Mill/Lathe
View Single Post
Old 11-17-2014, 08:37 AM
Dan's Avatar
Dan Dan is offline
Join Date: May 2008
Location: Moosylvania
Posts: 11,850
Default Re: Mill/Lathe

Been planning a saddle mounted 4 smoke build ever since I saw Dave's Junk Yard Dog build. Yrs back I bought some flat steel to make the mount and it sat rusting and collecting spiders since.

But is .250 thick and real hard steel. Same as the practice set I bought. (Thanks again guys!)

But was cutting it up to make key stock as I need an odd size. But then ground a sliver of it into a tool. Worked awesome! I now have enough tool stock for life. Gotta get some half inch but this works great.

Could make a hundred at least out'a this flatstock.
Attached Images
File Type: jpg shop tool stock.jpg (581.7 KB, 16 views)
worst apocalypse ever
Reply With Quote