View Single Post
Old 11-16-2014, 06:27 AM
highstrung74 highstrung74 is offline
Motorized Bicycle Member
Join Date: Nov 2014
Location: illinois
Posts: 44
Default Re: Drilling and Tapping JB weld

Originally Posted by fischer550 View Post
A friend of mine stripped his female exhaust holes, tried to drill and tap to M8 but he did that wrong too, and he screwed that up too. I have filled his holes with JB weld (which it says can hold constant temp of 500 degrees) and after 24 hours am planning on correctly drilling and tapping the jb weld holes back to M6. will it work?
replace the jug for 25.00 and be done with it and have a fresh topend while at it...might wanna do the rings while apart jus cause your in there...
Reply With Quote