View Single Post
Old 11-14-2014, 08:02 PM
MotorBicycleRacing's Avatar
MotorBicycleRacing MotorBicycleRacing is offline
Motorized Bicycle Elite Member
Join Date: Jul 2010
Location: SoCal, Orange County.
Posts: 5,353
Default Re: Pretty little 49cc engine!

Originally Posted by 2door View Post
Have you actually measured the bore and stroke to confirm the CCs? Obviously someone has installed an aftermarket slant head. I don't know of any (I might be wrong here) that had 6mm stud holes so the head must flop around somewhat on the small studs. Will that present a problem seating the head on the gasket sealing surface or are you going to use a 49 head?

That is the original head off a Naitong JaiLi 48cc motor and they have 6 mm holes. The 48 cc cylinders had 6 mm holes too.

Mine had the JL logo cast on the underside of the head and on some of the covers.

They also made a 48cc with the same round exhaust port and an iron liner.
The carb bolted right on the back of the cylinder so did not use an intake.
Reply With Quote