View Single Post
Old 01-28-2009, 05:36 PM
Bikeguy Joe Bikeguy Joe is offline
Godfather of Motorized Bicycles
Join Date: Jan 2008
Location: up north now
Posts: 11,531
Default Re: Paint and Wire Tuck?

Here's the lowdown on frame drilling-

Drill at 90 degrees to the load axis. That is to say the sides of the down tubes, chainstay, or cantilever tubes, not the top or bottoms of them. Also, drill the smallest hole possible and use a de-burring tool one done drilling. Follow those rules and you should be fine.
Reply With Quote