View Single Post
Old 09-19-2014, 09:23 AM
Jonda500 Jonda500 is offline
Motorized Bicycle Senior Member
Join Date: May 2014
Location: Canberra, Australia
Posts: 74
Default Re: Motorized Bicycle Take a Tip...Leave a Tip

I have realized that tightening the clutch flower nut increases the pressure on the clutch plates which is what I did after degreasing the clutch didn't stop it from slipping. However this means the push rod and ball bearing that sit under the sprocket cover need to be pushed further in before the clutch disengages- in my case the lever on the engine swung right around with out even touching the push rod -the solution is to grab a bit of steel rod the same size and cut a new slightly longer rod! (just file the ends flat and camfer off the corners a bit.)
Reply With Quote