Thread: Tank petcock
View Single Post
Old 08-15-2014, 01:21 AM
SchwinnStingray SchwinnStingray is offline
Motorized Bicycle Senior Member
Join Date: Apr 2014
Location: Australia
Posts: 58
Default Re: Tank petcock

I, if you really could not weld, would just cap off the pet cock thread where it is and buy a chinese $2.87 pet cock, the ones that fit the plastic pocket bike tank, they have a thread insitu that uses two nuts to lock in with a rubber o ring on the outside to seal.
Drill a 10mm hole, stuff around for two hours trying to get the nut on the inside to screw to the pet cock from the outside and your laughing.
Obviously, if you choose this route, you will need to position the pet cock as close to the filler as possible.
Reply With Quote