View Single Post
Old 07-23-2014, 10:12 AM
turnofftheradio's Avatar
turnofftheradio turnofftheradio is offline
Motorized Bicycle Elite Member
Join Date: Sep 2012
Location: America's Hi-five
Posts: 242
Default Re: Splitting the crankcase

Originally Posted by Blm25super View Post
Ok well my clutch shaft willl not go through the bearings because of the piece that sticks out . there is a piece that sticks out on each side of the clutch shaft(sprocket side and clutch side) . It seems to move and i was thinking that it would fold into the crank shaft if i can push it far enough but im not sure i can push it that far because the piece on the other side will butt up to the seal and bearings not allowing me to get it any further so i can fold it in ? if it even folds in?
is it the key for the crank holding you up? You can take the key out with a pick or small screwdriver. Don't lose it Don't beat too hard on the threaded ends, as stated it's amazing how soft they are.
Torker Boardwalk Custom-66cc 2stroke/NT/41t-Gps 36mph-
Friend of the white wire
Reply With Quote