View Single Post
Old 07-23-2014, 07:30 AM
Blm25super Blm25super is offline
Motorized Bicycle Member
Join Date: Jun 2014
Location: indiana
Posts: 28
Default Re: Splitting the crankcase

Ok well my clutch shaft willl not go through the bearings because of the piece that sticks out . there is a piece that sticks out on each side of the clutch shaft(sprocket side and clutch side) . It seems to move and i was thinking that it would fold into the crank shaft if i can push it far enough but im not sure i can push it that far because the piece on the other side will butt up to the seal and bearings not allowing me to get it any further so i can fold it in ? if it even folds in?
Reply With Quote