View Single Post
Old 06-27-2014, 09:28 PM
xseler's Avatar
xseler xseler is offline
Motorized Bicycle Elite Member
Join Date: Apr 2013
Location: OKC, OK
Posts: 2,426
Default Re: what did you do to your motorized bicycle today?

Originally Posted by Cyclin View Post
Today I received my JNM X-port and went to install it, but it would not fit on there stock. Pulled out the workstation attachment for the Dremel and used it to cut a couple mm off 4 of the wings and it was good to go. Trimmed the gaskets on the same setup then adjusted the support bar on the frame for the rear of the expansion chamber.

Didn't really change much but I did feel a little more torque on the acceleration. Should be good to go when i step down to the 36T sprocket as soon as it arrives next week

Everything feels right with the world when you can mod a mod!
You're never lost until you run outa gas.
Reply With Quote