Thread: permatex timing
View Single Post
Old 06-16-2014, 12:40 PM
Motorized Bicycle Elite Member
Join Date: Jul 2010
Location: CA
Posts: 1,742
Default Re: permatex timing

I used that stuff, and I intend for it to hold a little pressure from the hose going from the 4 stroke engines crankcase breather to the carb.

While I was going to check the valve between the breather and the carb, the low pressure of my breath to check bubbled the stuff.

It was not even 1 hr set so adding more of the stuff and smoothing it out and have it set for a day and was good to go. I did not test it yet as I have to get time and place to ride legal. It is OHV reg only, not for streets.

Vibration may not be good for it while it goes from 1 hr to 24 hr mark, but I would think it less critical than my application.

Reply With Quote