View Single Post
Old 06-14-2014, 09:26 AM
Davezilla's Avatar
Davezilla Davezilla is offline
Motorized Bicycle Elite Member
Join Date: Mar 2014
Location: San Antonio Texas
Posts: 2,710
Default Re: Centrifugal clutch.....clutch adjustment

That second pic you showed is the correct way it goes, I ran into the problem where my shaft extension wouldn't go into the bearing and had to lathe off a few thousandths before it would even go on, then when it did it was rough and didn't turn as free as I would have liked so I took it apart again and shaved off a few more thousandths off the shaft extension then re polished the extension and reinstalled it and everything is smooth as butter.

For the regular clutch, I just left mine adjusted the saem as if the centrifugal wasn't there and it did opk, you may want to tighten up the flower nut some tho if you feel it slipping, but if it's not slipping when you take off it's adjusted good enough.

I gotta run for now, but can explain more on this later if needed...
Reply With Quote