View Single Post
Old 06-08-2014, 05:19 PM
ishman ishman is offline
Motorized Bicycle Member
Join Date: May 2014
Location: Michigan
Posts: 47
Default Hey Dudes! Another first timer from Detroit!

I just bought a 66cc kit from Fast Bike Motors. I researched for a while and finally just jumped in. I ordered a pull start and a centrifugal clutch with it and I went to install the clutch today and found that the new cast alum. cover that came with the kit interferes with the original clutch so bad you cant rotate the clutch/ sprocket shaft. I watched a youtube vid on the subject and the guy uses 5 gaskets between the engine case and the side cover so he can drill a hole for lube access to the centrifugal clutch, he never said that it was necessary for clearance. Anybody have a similar experience? I did a search, no luck.

Thx, Ishman
Reply With Quote