Thread: need for speed
View Single Post
Old 06-04-2014, 08:06 PM
Davezilla's Avatar
Davezilla Davezilla is offline
Motorized Bicycle Elite Member
Join Date: Mar 2014
Location: San Antonio Texas
Posts: 2,710
Default Re: need for speed

I gotta agree with Map on this since he does have some exceptionally fast bikes without a lot of the hype... just a good bottom end and some decent port work... I think he's even still using the stock NT carb.
I recently built another engine with the DAX Gen4 bottom end and used my original ported cylinder, cut piston, and Fred head with a CNS carb then I put a good pipe on it and it's plenty fast even with the 44 tooth sprocket. I'm really happy with the performance and smoothness of this engine and can't wait til it's got about 300 or so miles on it. I may go up to a 40 tooth sprocket for a little more on top but I want to see how fast it really is before swapping anything else out. It does accelerate really nicely with the 44 tooth and I'm guessing high 30's from the few full speed runs I was able to get on it so far...

By the way Kat... You got a really nice looking ride too
Reply With Quote