View Single Post
Old 05-22-2014, 01:10 PM
Rump Rocket Rump Rocket is offline
Motorized Bicycle Member
Join Date: May 2014
Location: Michigan
Posts: 26
Default Re: looking to get into motorized biking

Originally Posted by mrfubs View Post
I strongly recommend taking the head off take the cylinder off and lubercate the cylinder wall and the conmecting rod bearings with raw 2 stroke pre mix so there is no dry start.
I was thinking of doing a motor flush using WD-40 to remove any debris that may of been left inside the motor during assembly by removing the head than re-lubing like you mentioned, is a certain bolt sequence and torque needed for reassembly?
Reply With Quote