View Single Post
Old 05-21-2014, 09:10 PM
Mitchg95 Mitchg95 is offline
Motorized Bicycle Member
Join Date: May 2014
Location: Lakewood Colorado
Posts: 43
Default Re: Making a custom bike engine

This part, I just designed will go I between the case segments. This part is supposed to hold bearings to support the shaft. The reason it is so long, the rounded circular parts will fit into the case, this will provide more rigidity to the engine

It will be made out of two square blocks. They will be milled to equal thicknesses of 1.5 thick and 3inches wide, then bolted together and the circular details will be turned and bored out for the shaft and bearings
Reply With Quote