View Single Post
Old 05-18-2014, 08:48 PM
Mitchg95 Mitchg95 is offline
Motorized Bicycle Member
Join Date: May 2014
Location: Lakewood Colorado
Posts: 43
Default Re: Making a custom bike engine

I am not sure yet on how I will go about this, a thought that I had is if I made the partitions that go between the case segments, If I made those out of two parts that bolt together so I could install the bearing on the shaft, then put the shaft between the halves, and bolt the halves together.
Thanks for the bore and stroke information. Ive started drawing out a front view of a case segment.
I need to find out at least, the width of the cylinders so I can set a outside dimension for the case. Ive decided to offset the cylinders at 45 degrees to help with cooling.
Reply With Quote