View Single Post
Old 05-17-2014, 11:50 PM
magna_503 magna_503 is offline
Motorized Bicycle Elite Member
Join Date: Apr 2009
Location: Portland, OR
Posts: 251
Default Is your spindle/crank combo too short and you need to extend them?

Well, I have to extend my spindle / crank combo since it was too short to clear the jackshaft sprocket. Extending the spindle/shaft below.

It's already 206mm long but not long enough. To extend it, here's what I came up with...

2 on each side 5/8" split shaft collar cut out my 153mm shaft, weld the too collars together and clamp both ends to the 206mm shaft. That's the plan. Pic is of 5/8" shaft 10" long if i want to go that route too.

I could definititely use one of these
but I'm cheap and don't want to spend $34 for it, add shipping/handling fee and you're looking at $40. hahaha...

Last edited by magna_503; 05-18-2014 at 12:22 AM.
Reply With Quote