View Single Post
Old 05-12-2014, 10:48 AM
mapbike's Avatar
mapbike mapbike is offline
Motorized Bicycle Elite Member
Join Date: Mar 2010
Location: Central Texas
Posts: 5,379
Default Re: Exhaust tube bending

Looks like that worked out real good for ya, you can also leave a piece of pipe a couple inches longer than it needs to be, solder or braze a block off cap or plate on one end, fill the pipe with sand and then braze a cap. On the other end also, then you can bend the heck outta the pipe and it wont kink because the sand gets tighter inside as it bends and keeps so more pressure forcing outward in pipe that it holds it shape good.

Just wanted to add another way to do it here also wret, hope you don't mind and it looks like you wound up with a real nice looking pipe there.

I dont always ride WOT, but when I do..I do my best to keep the rubber side down..Ride safely my friends!

Last edited by mapbike; 05-12-2014 at 12:55 PM.
Reply With Quote