Thread: Clutch pads
View Single Post
Old 03-31-2014, 11:41 PM
mapbike's Avatar
mapbike mapbike is offline
Motorized Bicycle Elite Member
Join Date: Mar 2010
Location: Central Texas
Posts: 5,379
Default Re: Clutch pads

If the pucks look glazed over on the inward side just take each out ata time and rough it up a bit on some 80 grit sand paper and put them back in and make sure clutch is adjusted right, sanding them like this removes the hard glaze that forms from heat and slippage and makes them about as good as new again.

I dont always ride WOT, but when I do..I do my best to keep the rubber side down..Ride safely my friends!
Reply With Quote