View Single Post
Old 03-06-2014, 01:01 AM
Lachiepower0402 Lachiepower0402 is offline
Motorized Bicycle Elite Member
Join Date: Mar 2014
Location: Eastwood
Posts: 111
Angry Re: Got problems, please help!!

I just released when i was tightening the back studs the right was pretty tight because i was going to go back to it, then i was doing the left one and when it was almost fully tight the right one popped and came out and i am pretty sure it runied the thread in the engine. Also the front ones are too short. Last of all when i have the motor in this position i can see that it would rub the bottom of the inside of the chain case. What the **** can i do, all of my problems are the motor mount. The engine runs and everything. This is so stupid!!!!
Reply With Quote