View Single Post
Old 02-03-2014, 08:43 PM
Greg58's Avatar
Greg58 Greg58 is offline
Motorized Bicycle Elite Member
Join Date: May 2011
Location: Newnan,Georgia U.S.A.
Posts: 2,621
Default Re: n00b With new china motor stumped

Are you still using the brass looking push together connectors? Sometimes they do not make good connection. If the connector is not the problem use your meter to test the blue wire, set it to ohms and touch the leads together to check meter operation then touch one lead to the end of the blue wire and the other to the solder joint on the coil. The meter should zero out or the needle should swing , move the wire around and see if you loose the connection. On one bike I had a new kill switch that the wire was broke inside so it could happen on a magneto.
Your results may not be the same,Greg
Reply With Quote