View Single Post
Old 01-17-2014, 11:43 AM
djnutz djnutz is offline
Motorized Bicycle Newbie
Join Date: May 2010
Location: South Dakota
Posts: 19
Default Re: Longtime lurker, first time poster

For the gas tank, I used chrome door edge molding around the "fin". I cut the mounting bolts shorter. Heat shrink tubing on the brackets. A small piece of bike tube rubber between the tank and bike top tube. I used chrome cap nuts, chrome flat and lock washers to tighten it all down.

Fuel filter is from a local lawnmower shop. The hose barb from the tank is from the plumbing department at Menards. Fuel tubing is from the auto parts store.

The other pic is of my solution for cables. This is a single zip tie and a small section of vacuum tubing. Tie goes through the tubing, then around the cable housing, then back through the tubing again, then around the frame as you normally would.
Attached Images
File Type: jpg IMG_20140117_101309_537.jpg (222.3 KB, 35 views)
File Type: jpg IMG_20140117_101327_099.jpg (189.0 KB, 41 views)

Last edited by djnutz; 01-17-2014 at 11:45 AM.
Reply With Quote