View Single Post
Old 11-29-2013, 08:35 PM
onetime onetime is offline
Motorized Bicycle Newbie
Join Date: Nov 2013
Location: florida
Posts: 9
Default Re: Newbe looking for help........

The bucking bar had to initially been in place because the actuator cover was on tight before I installed the chain. So no double bearings. The bucking bar is not bound up. I've applied pressure and following adding grease some was forced out when I put the bucking bar back in. It is just too far out to allow the cover to be reinstalled. I'm beginning to wonder if I should attempt to open the right side and remove the clutch. Could the clutch spring(s) be pushing the bar back out the left side?
Reply With Quote