View Single Post
Old 11-29-2013, 08:03 PM
onetime onetime is offline
Motorized Bicycle Newbie
Join Date: Nov 2013
Location: florida
Posts: 9
Default Re: Newbe looking for help........

The actuator arm is installed correctly greased and pointing towards rear of bike. The clutch push rod or bucking bar will slide out and is well lubed. I can feel the ball bearing with a screw driver head but cannot remove. Believe it is stuck in grease. I have tapped the flower nut and the rod with a plastic mallet (other similar posts). No further movement. Still preventing actuator cover replacement. Cover was on when I mounted the engine. Any other ideas?
Reply With Quote