View Single Post
Old 12-27-2008, 10:09 PM
Creative Engineering Creative Engineering is offline
Join Date: Sep 2008
Location: Clearwater, FL
Posts: 1,668
Default Re: New Build (raw engine)

Originally Posted by Airbuzz View Post
I'll check out your other thread. I saw your 3-d rendering on the first page and this is what I commented on. I didn't recognize that there was a whole 2 other pages of posts after the first. As to my sketch… I could do some 3-d models but it would take too long. 10 minutes for the sketch, 5 minutes to scan and post. Always do the least.

If you would bend up the sheet metal based on my my drawing that would be great! It seams ridiculous having it done in Florida but you know what I'm after. I’d rather not go thru a learning curve finding someone around here. I’ll pay. Thanks Jim.
No problem! I'll need to know the U-clamp, (threaded portion), centerline distance, and the distance from the engine mount to the frame.

Reply With Quote