View Single Post
Old 12-27-2008, 09:58 PM
Airbuzz Airbuzz is offline
Motorized Bicycle Member
Join Date: Aug 2008
Posts: 49
Default Re: New Build (raw engine)

I'll check out your other thread. I saw your 3-d rendering on the first page and this is what I commented on. I didn't recognize that there was a whole 2 other pages of posts after the first. As to my sketch… I could do some 3-d models but it would take too long. 10 minutes for the sketch, 5 minutes to scan and post. Always do the least.

If you would bend up the sheet metal based on my my drawing that would be great! It seams ridiculous having it done in Florida but you know what I'm after. I’d rather not go thru a learning curve finding someone around here. I’ll pay. Thanks Jim.

I can't find that thread Jim that you mentioned, can you send me a link?

Last edited by Airbuzz; 12-27-2008 at 10:03 PM. Reason: lost thought
Reply With Quote