View Single Post
Old 11-25-2013, 09:28 AM
Jumpa's Avatar
Jumpa Jumpa is offline
Motorized Bicycle Elite Member
Join Date: Aug 2011
Location: Cape Cod
Posts: 606
Default Re: Motorized Bicycle Take a Tip...Leave a Tip

Some of the bikes I've built over the years have the cables running along the top of the tank tube ive re-routed them Ive eliminated them however the best idea Ive had to deal with this is to use a screw from an old bake lever that has the slot cut in it First I cut some rubber tubing lay that out flat then I put 1 or 2 on each cable . One does it because I rest the tank on the welded cable mount near the gooseneck Th cable then moves freely under the tank between the screws and the tank stays snug even though the contact points are greatly reduced & the rubber helps from scratching vibration etc .I took a photo of a demo kinda brite "the flash went off" but if you look close you'll get the idea
Attached Images
File Type: jpg demo.jpg (42.1 KB, 51 views)
Reply With Quote