View Single Post
Old 12-21-2008, 04:00 PM
Walter F.'s Avatar
Walter F. Walter F. is offline
Motorized Bicycle Elite Member
Join Date: Jun 2008
Location: Connecticut
Posts: 326
Default Re: Where can I find these?

The little ball bearing is a M8, the little rod is another story, depending on engine size it's any where from 25mm to 28mm. Creative Engineering discovered this by accident when they brought out their clutch actuator.
My 49cc was 27.9mm and my 70cc was 25.6mm, so with the little rod cut you a piece of 5/16" cold rolled rod from the hardware, cut it about 1-1/8" long and keep grinding it down till it works, sorta like "shoot till ya win" also one end of the rod wants to be rounded this end points out, the square end goes against the M8 ball bearing. Good Luck & I hope this helps Walter F.
Reply With Quote