View Single Post
Old 09-19-2013, 08:15 PM
dodge dude94's Avatar
dodge dude94 dodge dude94 is offline
Motorized Bicycle Elite Member
Join Date: Jun 2012
Location: East Texas
Posts: 1,017
Default Re: My mongoose beast project

Originally Posted by felix2 View Post
dodge dude, yes i cut the seat tube out all the way to make room, then cut a piece off of it and used that to make the front mount. i used the left over tube to make the rear post mount. eventually i think i'll have to tie in that off center post in the rear that i welded back into the point up top where i cut it out...if that makes sense, for structual integrity. either that or put some gussets some where.
I think you should gusset that triangle. We know these china bikes aren't the best quality, I'd had to see you blow the frame at 15mph. Or however fast this thing will go with those ginormous tires.
2 WHEELS: '11 Huffy Good Vibrations, '11 Skyhawk GT5, 44t, CNSV2, NGK BPR7HIX, Bosch wire, shutupexhaust, 26x1.75kevlar tires, Tektro C230's, new stupid Bell chain
Reply With Quote