View Single Post
Old 09-19-2013, 10:42 AM
mapbike's Avatar
mapbike mapbike is offline
Motorized Bicycle Elite Member
Join Date: Mar 2010
Location: Central Texas
Posts: 5,379
Default Re: My mongoose beast project

As wide as that rear tire is I see no way you will ever have proper chain alignment unless the engine is offset 3/4"-1" from centerline of frames down tube, if it is twisted any at all you will never keep a chain on it, if this has been done and I can see it in the pic then disreguard this part of this post.

The intake in the link I posted below along with either the RT carb that Dax sells or even a standard NT kit carb will like ly solve the carb clearance issue you have going on there.

If you are using a super long rubber hose for an intake chances are you will never get the carb acting right.

I dont always ride WOT, but when I do..I do my best to keep the rubber side down..Ride safely my friends!
Reply With Quote