View Single Post
Old 12-18-2008, 10:59 PM
christianava12 christianava12 is offline
Motorized Bicycle Newbie
Join Date: Dec 2008
Location: San Diego CA
Posts: 6
Default Re: 80cc that will not start

Major improvement, The clutch "flower" nut was just to loose, I have got the engine running now. I think that I do have a little bit of chain alignment issues right now as the chain jumped off a couple of times but as soon as I moved the idler wheel it seemed to stop coming off. Right now it feels like I have a lot of vibrations which I think are because of a loose wheel bearing in the rear hub. My other problem right now is that I have no throttle control, I have tried to adjust the cable at both ends but it seems to make no difference, so the only way I could control the speed on a test drive down the street was with the choke.

Any ideas on that one?
Reply With Quote