View Single Post
Old 09-08-2013, 08:53 AM
xseler's Avatar
xseler xseler is offline
Motorized Bicycle Elite Member
Join Date: Apr 2013
Location: OKC, OK
Posts: 2,427
Default Re: Toasted a wheel bearing on my Cranbrook.

I give my Cranbrook wheel a good shake before I take it out for anything more than a putt around the neighborhood. So far, so good (after I had an issue and replaced the bearings, used Red 'n Tacky grease, and spent a good amount of time adjusting the cones).

If I were relying on this bike for my only means of transportation, this wheel would probably be kinda sketchy. However, since this is my 'fun vehicle', I'll just run it until it won't run no more.......
You're never lost until you run outa gas.
Reply With Quote